Hi Alan,
Archive function not available If you cannot find the AutoArchive and Archive settings in the aforementioned locations and you are working in a corporate environment, it could have been disabled by your administrator as a Group Policy.
This error is caused because the computer does not recognize the printer driver.
Before I proceed further, I would like to know the information below,
Method 1: I suggest you to disable the third party Antivirus Running, and try installing the printer.
THIRD PARTY LINK DISCLAIMER:
A Fatal Error Occurred While Trying To Sysprep
Disclaimer: Using Third Party Software, including hardware drivers can cause serious problems that may prevent your computer from booting properly. Microsoft cannot guarantee that any problems resulting from the use of Third Party Software can be solved. Usage of Third Party Software are done at your own risk.
Method 2: Try installing the HP drivers and software in clean boot state, by disabling the third party programs affecting the installation.
Click on the link to install the HPLaser Jet Pro MFP M125nw Printer drivers in the clean boot state.http://support.hp.com/us-en/drivers/selfservice/HP-LaserJet-Pro-MFP-M125-series/5396664/model/5303404
Clean boot.
Check if any third party application is causing the issue, as clean boot helps in eliminating software conflicts.
A clean boot is performed to start Windows by using a minimal set of drivers and startup programs. This helps eliminate software conflicts that occur when you install a program or an update or when you run a program in Windows. You may also troubleshoot or determine what conflict is causing the problem by performing a clean boot. You must log on to the computer as an administrator to be able to perform a clean boot. Your computer may temporarily lose some functionality when you perform a clean boot. When you start the computer normally, the functionality returns. However, you may receive the original error message, or experience the original behavior if the problem still exists. If the computer is connected to a network, network policy settings may prevent you from following these steps.
Once you perform clean boot do refer to the section “How to reset the computer to start normally after clean boot troubleshooting” to boot the computer in normal mode.
Reference: Fix problems that block programs from being installed or removed
Hope this helps. If the issue persists, please do let us know and we would be happy to help you further.
Thank You
A Fatal Error Occurred Hp Connection Manager
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |